[ Start ] [ Omhoog ] [ Products ] [ Brands/Merken ] [ English ] [ Nederlands ] [ Map/Route ]    

-u kunt geld besparen door te vertrouwen op uw gehoor-

To own separate control and power amplifiers is the dream of many a music enthusiast. Imagine having that level of performance in a single box. The PLINIUS 9200 captures the finesse, authority and subtlety of the best separates and combines them without compromise in an elegant enclosure. With some 200 Watts per Channel available, the PLINIUS 9200 will drive the most ambitious of loudspeakers to satisfying levels while remaining composed and dignified.

The PLINIUS 9200, based on the PLINIUS Odeon Amplifier Module physically separates the control and power sections for absolute performance, and by housing them in the same chassis removes the requirement for expensive interconnecting cables.
 

It is widely recognised that vinyl reproduction is the primary choice of many music lovers, and the Phono Stage in the PLINIUS 9200 will allow enthusiasts to extract the very best performance from their record collections. Of course the PLINIUS 9200 will also do full justice to any digital source. The on board Processor Loop allows direct connection and control from an external Home Theatre Processor.

The design team responsible for the PLINIUS Odeon have forged and moulded a chassis of function and beauty from the very best materials and this heritage guarantees performance and long term reliability.

The inside of the 9200 integrated amplifier is crowded with circuitry. The input board to the top of the amplifier holds the microcontroller circuitry and regulation, line stage, and phono stage to the right of the board. The record and source selectors as well as the volume control are also interfaced with this circuit board. Underneath is the main board that consists of powerful left and right power amps, house keeping pre-regulation, and power supply for the power amps. As with all Plinius product, all this circuitry is supplied by a high quality toroidal transformer to the front of the amplifier.

		Power: 200 Watts RMS per channel into 8 Ohms. Both channels driven from 20Hz to 20kHz at less than 0.2% total harmonic distortion. Frequency Response: 20Hz to 20kHz ± 0.2dB, -3db at 5Hz, -3db at 70kHz. Distortion: Typically <0.05% THD at rated power, 0.2% THD and IM worst case prior to clipping Saturation: 300 Watts per channel or greater into 4 Ohms. Current Output: 40A short duration peak per channel. Fuse protected. Slewing: 50V/us. Hum & Noise: 90dB below rated output 20Hz to 20kHz unweighted. Input Sensitivity: 300mV RMS for rated output at 1kHz. 1.5mV RMS on Phono low gain setting. 0.75mV on Phono high gain setting. Input Impedance: 47k Ohms. Input Overload: 5V RMS. Phono Stage Gain: 66dB on high gain setting, 60dB on low gain setting (Phono Input To Pre-Out). Rated Pre Out Level: 1.5V RMS into 47k Ohms or higher. Maximum 6V RMS into 10k Ohms or higher. Pre Out Source Impedance: Typically 1.5k Ohms. Pre Out Minimum Recommended Load: 47k Ohms. Tape Output Level: 190mV at 200 Ohms. Tape loop muting at 5V RMS input. Dimensions: Height 120mm (4.75"), Width 450mm (17.75"), Depth 400mm (15.75"), Weight 14kg (30lbs).